LabTek is a renowned manufacturer, supplier, solution provider and exporter of Concrete testing machines, building and civil engineering laboratory equipment and accessories. We are supplying the equipment to quality testing laboratories civil builders, civil contractors, Engineering colleges, Universities and Polytechnics. We manufacture the best quality Automatic Compression testing machines, Semi Automatic or Digital Compression testing machines, Electrical cum Hand Compression testing machines, Hand operated or Manual Compression testing machines or Cube Testing Machines or Compressive strength testing machines as per the international standards and specifications. concrete straight edge, aluminum concrete straight edge.
Specification: Used to remove excess material when molding cube and cylinder specimens. Conduction slump cone and air meter tests. Flat bar made from steel.
1” X 12” (2.5 X 30.4CM)
Compressive strength testing machines as per the international standards and specifications. concrete straight edge, aluminum concrete straight edge, concrete straight edge float
Compressive strength testing machines as per the international standards and specifications. concrete straight edge, aluminum concrete straight edge, concrete straight edge float, concrete straight edge home depot, 16 foot aluminum straight edge, concrete screed boards.
There are many tools for finishing concrete surfaces, but this article will deal only with those tools that are used to finish horizontal concrete surfaces. A straightedge or strike-off rod is usually a straight piece of 2 by 4 or a 1 by 4 with a one and a half by 2 inch shoe strip attached to the bottom. It can, however, be made of any straight piece of wood or metal that has sufficient rigidity. The straightedge should be longer than the widest distance between the screeds or edge forms. It is the first finishing tool used by the cement mason after the concrete is placed and is used to strike off or screed the concrete surface to proper grade. After the concrete has been struck off, hand tampers can be used to compact the concrete into a dense mass. They are used on flatwork construction with low-slump concrete because such concrete is usually quite stiff. Tampers are used to force the large particles of coarse aggregate slightly below the surface in order to enable the cement mason to put the desired finish on the concrete surface. The tamper should be used only sparingly and in most cases it is not recommended and not necessary. A darby is a long, flat, rectangular piece of wood, aluminum or magnesium from 30 to 80 inches long and from 3 to 4 inches wide with a handle on top. It is used to float the surface of the concrete slab immediately after it has been screeded, to prepare it for the next step in finishing. This tool should be used to eliminate any high low spots left by the straightedge and to sufficiently embed the coarse aggregate for subsequent floating and troweling.