The “LabTek The trainer features a large refrigeration chamber. Two evaporators allow for an investigation of the effect of different evaporator sizes on the cold storage room climate and the icing. An electric defrost heater and hot gas defrosting are available. The defrost process can be performed as required using a defrost controller or at set intervals using a defrost timer.
Two adjustable heat sources in the refrigeration chamber simulate the cooling load. One of these heat sources generates water steam to simulate the introduction of humidity into the refrigeration chamber.
The measured values can be read on digital displays. At the same time, the measured values can also be transmitted directly to a PC via USB.
The data acquisition software is included. The data acquisition enables e.g. the recording of the defrosting process over time and the online representation of the climate in the refrigeration chamber in the h-x diagram. The flow rate of the refrigerant is determined by means of the pressure measurement.
Refrigeration capacity at -5/55°C: 999W
Power consumption: 565W
Latent cooling load: 2x 0…250W
Sensitive cooling load: 1x 0…200W, 1x 0…250W
Filling volume: 1,3kg
Pressure: 2x 0…16bar, 1x 0…25bar
Temperature: 7x -50…150°C; 1x -25…125°C
Rel. humidity: 0…100%
Flow rate: 2…27L/h
230V, 50Hz, 1 phase
230V, 60Hz, 1 phase
DIMENSIONS AND WEIGHT
The best way to experience wide collection of products is to visit the store.